Sewer Pipe Lining (CIPP) in Fort Lewis

What fails under Fort Lewis homes

Older Pacific Northwest neighborhoods were built with concrete and clay side sewers, sometimes with sections of Orangeburg (tar-impregnated fiber) pipe from the 1950s and 60s that has since deformed. Cast iron runs under the house; the side sewer to the street is often long and deep on hillside lots.

Wet ground for much of the year, big root systems from firs, cedars, and maples, and hillside soils that creep downslope all work on sewer joints. Groundwater makes open trenches slow and messy, and many side sewers run under sidewalks and streets that the city requires be restored to standard.

Lining handles the root-intruded clay and concrete; bursting replaces the Orangeburg and collapsed runs; both avoid digging up a wet hillside yard or cutting a city street.

How cured-in-place lining works

A felt or fiberglass tube is saturated with resin, pulled or inverted into the cleaned host pipe, pressed against the wall with air or water, and cured with hot water, steam or UV light. When it hardens you have a new, jointless pipe inside the old one. The liner takes up a small amount of diameter, but its smooth wall flows better than corroded cast iron or offset clay. Lateral liners are typically rated for a 50-year service life.

What has to happen first

A camera inspection to map the line and every branch connection, hydro jetting to strip roots and scale so the resin bonds to clean pipe, and measurement so the liner is cut to length. After the cure, branch connections are reopened from inside with a robotic cutter and the line is filmed again.

When lining is the right fix

• Root intrusion at joints, longitudinal cracks, small offsets, pinholes or channeling in cast iron — on a pipe that is still round and holding grade.
• Lines under slabs, driveways, mature landscaping or streets, where the cost of a trench is mostly the cost of restoring what is above it.
• Coastal and high-water-table lots where an open trench means dewatering and shoring.

When it is not

Collapsed pipe, bellies that hold standing water, and lines that were undersized to begin with. A liner follows the host pipe's shape, so a bad shape stays bad. Those lines get pipe bursting or a spot replacement. Under-slab cast iron with several tight bends usually gets a spray-applied liner rather than felt.

Questions worth asking

What resin system and cure method will be used, what the liner's rated life is, whether the branch connections were counted, who pulls the permit, and whether you will receive the before-and-after video. A contractor who does this every week answers all five without hesitation.

Getting it done in Fort Lewis

A camera inspection maps the line and marks every defect on the ground with its depth. The line is cleaned with a hydro jetter so the pipe wall can be seen and, if it is being lined, so the resin bonds to clean pipe. Lining works from the cleanout at the house; bursting needs a small pit at each end of the run. Either way the yard, driveway and slab in between are never opened. Most residential jobs in Fort Lewis finish in a day, and you should receive the before-and-after footage as part of the job.

Permits are part of it. Lateral work in Fort Lewis normally needs a plumbing permit, and anything in the sidewalk, parkway or street needs a right-of-way permit as well. The contractor pulls those and schedules the inspection; if a quote does not mention them, ask.

Finding the right contractor in Fort Lewis

Fort Lewis does not have a CIPP Verified installer assigned yet. The curedinplacepipe.net directory lists vetted lining contractors by state. The form below and (877) 880-8125 both reach our network directly; we match the request with a qualified contractor covering Fort Lewis. Estimates are free. Call now.

More trenchless services in Fort Lewis

Questions we hear in Fort Lewis